Meade autostar 3
You can now use the Arrow keys (B) to slew (move) the telescope up, down, right, or left. The display then reads "Setup: Align." See page 11 for more information. Press ENTER (A) when the correct information for each prompt displays. Use the Scroll keys (D) to cycle through the lists of Country/States, Cities, and Telescope Models. – these functions will be explained later). (Ignore the prompts requesting "Date" and "Time" for now Keep pressing the ENTER key (A) until "Country/State" appears on the display. Press the Speed/? key (C) to accept the Sun warning. Īppendix B: Using Autostar to Enter Coordinates. Īppendix A: Equatorial (Polar) Alignment.
#Meade autostar 3 manual
Manual Operation Using Autostar's Arrow Keys. All rights reserved.ĭesign: Automated Telescope - Patent No. Patent Office and in principal countries throughout the world.
![meade autostar 3 meade autostar 3](https://img.yumpu.com/10984873/1/500x640/ls-series-manual-meade.jpg)
® The name “Meade,” the Meade logo, and “ETX” are trademarks registered with the U.S. If you are anxious to use your telescope for the first time, read the QUICK-START GUIDE on page 3. Improperly installed batteries void your Meade warranty. If these precautions are not followed, batteries may explode, catch fire, or leak.
#Meade autostar 3 install
Do not install batteries backwards or mix new and used batteries. Follow battery manufacturer's precautions. Children should always have adult supervision while observing.ĬAUTION: Use care to install batteries in the orientation indicated by illustration in the battery slots of the battery holder. Do not look through the telescope or its viewfinder as it is moving. Do not point the telescope or its viewfinder at or near the Sun. Eye damage is often painless, so there is no warning to the observer that damage has occurred until it is too late. The screen should go back to the keyboard display, with the text window showing your usual start-up message ("Daylight Saving" in my case, with the mount GPS turned off).Never use a Meade ® ETX ® Astro Telescope to look at the Sun! Looking at or near the Sun will cause instant and irreversible damage to your eye. No need to enter any settings in iPhone.Ħ) Go to the "Connect" screen, and enter first time settings of IP: 192.168.0.3 and Port: 5000ħ) Press "Connect to Scope". **** in DCE position, see above ****Ģ) Plug the WiFi Adapter into the left RS232 port on the mount.ģ) Switch on the WiFi Adapter and connect to its WiFi signal with your iPhone. Open a browser and go to 192.168.0.3 which is the built-in config pages.Ĭhange the Transmit Timer (mS) box to 10 (default is 100)ġ) The WiFi Adapter should have the DCE/DTE switch in the DTE position.
#Meade autostar 3 Pc
Install a virtual COM port on your PC with USR-VCOM utility.
![meade autostar 3 meade autostar 3](https://www.picclickimg.com/d/l400/pict/303951858757_/Meade-Autostar-Hand-Controller-with-Cord.jpg)
Set the slide switch on the adapter to DCE(F) So switch to DCE with stock #507 cable *****ĭ) An iPhone or iPad running iOS 6 or higher. **** I've since discovered that the DCE/DTE reverses TxD and RxD. Or buy a #507 and a "Mini Null Modem Male to Male adapter" : This way you can make the cable shorter and mount the Adapter near the mount without cable loops. The DB9 gender needs changing - the #507 has a female DB9, but the RS232 Adapter is female too. That's the one with a wide 6-pin RJ plug that fits the RS232 socket on the mount, not the #505 with narrower 4-pin plug that is used for updating the LX90/ETX type of Autostar: I used a 5V mini USB mains charger.Ĭ) Meade #507 data cable. You can also get packages of an uncased module plus antenna plus power supply for about £15 !!ĥ-27 Volt power source for the Adapter, either mini USB or bare ends.
#Meade autostar 3 pdf
This company also sells them from the UK, just not at the moment I did this search ! The UK delivery was fast, and they sent me a PDF of the manual when I asked them to, so good service.Īppears to be the same as a USConverters WA232. You can use SkyFi (£245), or Meade Stella (£219), or something like this (£30) - Umm, difficult choice. The app is called ScopeBox and it's on half-price at the moment, £4.99 in the App Store.Ī) You will need a Wifi RS232 Adapter. You don't even need the Autostar II handbox to set up the mount. There's a complete WiFi replacement app for the Autostar II handbox available, running on an iPhone or iPad.